The forklift industry jargon to understand?

Web Design And Seo For www.china-webdesign.com

fork lift truck attachments - China Manufacturer

Thank you for inquiry my fork lift truck attachments, Tel：13989310707, E-mail: sales@steelmanattachment.com

http://www.forklift-fork.com/key-fork-lift-truck-attachments-154/

 A rated lifting capacity: the rated lifting capacity of the forklift is the cargo center of gravity to fork

the anterior wall of distance is not greater than the load center distance, which allows a maximum weight of

liters of cargo, expressed in t (t). When the fork on the cargo center of gravity beyond the specified load

center distance, due to the the forklift longitudinal stability limit, from the weight should be reduced

accordingly.
    2, the load center distance: when the load center distance is the standard of the goods placed in the

fork, its center of gravity arrival fork vertical segment of the anterior wall of the horizontal distance in

mm (millimeters). 1t forklift requires the load center distance is 500mm.
    3, the maximum hoisting height: maximum lifting height is defined as a flat, solid ground: forklifts

loaded with goods rose to the highest position,forklift clamp attachment
the fork level segment on the surface of the vertical distance

from the ground.
    4, gantry angle, gantry angle is the maximum angle of no-load forklift in a flat and solid on the ground,

the door fram e relative to its vertical position forward or backward.telehandler attachments
The anteversion role is to facilitate

the fork to take and cargo unloading put; the role of the po sterior slope of forklift trucks with freight row,

preventing cargo from the fork slide. According to job needs
General forklift inclination of 3 ° to 6 °, an inclination of 10 ° after ~~ 12 °.
    5, the maximum lifting speed: forklift maximum hoisting speed usually refers to the forklift loaded with

cargo lifting the maximum speed at m / min (m / min). Maximum hoisting speed can improve operational

efficiency; hoisting speed over the limit, the accident prone cargo damage and engine damage. Domestic

forklift hoisting speed has been increased to 20m/min.
6, the maximum speed; improve the speed forklift improve operating efficiency. Opponents from the weight of 1t

of internal combustion forklifts, when loaded with the maximum speed of not less than 17m/min.
    7, the minimum turning radius: when the forklift in the no-load at low speed and played in the steering

wheel turning, the body most lateral and most medial to the minimum distance of the turning center,

respectively, referred to as the smallest outer turning radius the Rmin outside and minimum medial turning

radius rmin inside. Minimum outer turning radius is smaller the smaller the forklift turn requires a surface

area of ​​mobility as possible.
    Minimum ground clearance: Minimum ground clearance wheels outside the body on a fixed minimum point-to-

ground distance, it means that the forklift collision-free across the ground raised obstacles. Minimum ground

clearance is the greater, the higher the forklift.
    9, the wheelbase and tread: forklift truck wheelbase is the horizontal distance of the front and rear axle

centerline in the forklift. Tread means the distance from the center left and right wheels of the same axis.

The increased wheelbase and the longitudinal stability of the forklift, but the increase in body length, the

minimum turning radius increases. Increase the tread, the lateral stability of the forklift, but make the body

width and minimum turning radius increases.